How to replace a rear wiper blade on an Alfa Romeo
First of all make sure you have the correct wiper blade, there are two different length blades on 147’s depending if the car is fitted with a lip spoiler on the roof, you can
Locating the chassis number on your Alfa Romeo
All Alfa’s after 2005 had the chassis number etched into the original windscreen. On 159, Brear, Mito and Giulietta the chassis number is embossed under an access plate in th
How to get the hood on a Brera Spider back up if it fails
Okay so this is a bit of a tricky one to do in an emergency but it is possible, even for the less mechanically minded. The operation needs to be performed with the ignition OFF. Fi
Lifting the Alfa 4C
Front jacking point, note the triangular mark on the sill (red) that denotes its position, then there is a small section of under body protection (black) and then the carbon tub, n
Replacing The Front Wiper Motor And Linkage On An Alfa MiTo
Raise the bonnet, take off the the wiper nut covers and undo the nuts with a 13mm spanner. Remove the skuttle front trim and pop off the foam pads. Unscrew the three skuttle screws
How To Remove A Broken Door Handle On A 147/GT
Cut back the adhesive membrane foam, enough to get to the back of the door handle. Undo the three screws to the internal release bar guide. Unclip the guide, and pull out. Undo the
How To Remove The Front Interior Door Card On An Alfa 147 or GT
Prise off the cover by the interior door release handle. Undo the retaining bolt with a 5mm Allen key. Prise the panel off, and unclip the connector. Prise off the door handle cove
How to cure a faulty heated rear window on a GTV
To check if you have a problem first remove the fuse box cover. Then locate the tab at the back of the fuse box. Pull it towards you and the fuse box will hinge down. Examine the f
Rear Window Regulator And Motor Removal On A 159
Pull the top of the window corner trim to release the clip. Undo the 5mm Allen bolt under the window switch door well mat. Pull out the switch unit and unplug it. Prise the plastic
Dismantling The Front Bumper From A MiTo 1.4 Multiair Turbo
Undo the nine undertray screws, and the four T30 (Torx) screws underneath the front bumper. Undo the screws at either end, the three screws up the inside of the wheel arch lining,
