Removing The Bumper And Headlights From A Brera
Remove all of the undertray fixings. Undo the two Phillips screws on the wheel arch liner, and the 8mm top bolt on both sides. Along the top of the bonnet slam panel undo the four
Inner Door Card Removal On An Alfa Brera/Spider
Unscrew the x4 Phillip screws along the bottom of the door card…. …and the baby screw on the side of the door. Remove the x2 5mm allen bolts on the pull to handle. Pop
How To Remove The Front Wiper Motor and Linkage On An Alfa 147
Lift the boot then the protective covers on the wiper arms. Undo the 13mm nuts. On the passenger side pump the arm down a couple of times (it will spring back up) to loosen the fit
Removing The Front Sub Frame From An Alfa 159/Brera (4×2)
Undo the 17mm wheel bolts and remove the wheel. Undo the x2 T30 (TORX) screws to the wheel arch side panel. Remove the x2 6mm allen and x8 T30 screws to the under tray. Undo the 21
Replacing The Petrol Flap Release Solenoid And Pivot Spring Pin On An Alfa Giulietta (2010 Onwards)
Open the boot and on the right hand side locate the EMERGENCY petrol flap release cord and pull. Undo the Phillips retaining screw to the surround. Unscrew the fuel filler cap. Usi
Replacing The Bonnet Release Handle Support On An Alfa 159/Brera
This is the before and after shot of the bonnet release handle support. The release handle….hanging. There are x2 8mm bolts used to hold the bracket in place. We are going to
Replacing The Boot Wiring Looms On An Alfa Giulietta.
Lift up the boot and unclip the x2 parcel shelf straps. This is the boot covering the LEFT hand wiring loom. Pull the boot out and the excess wiring. Now pull the boot down until t
Replacing The Right Hand Interior Door Handle On A Giulietta
Prise off the small cover behind the interior door handle. Undo the 5mm allen bolt. Unscrew the Phillips screw to the right of the puddle light…. …and the side of the b
Replacing The Boot Wiring Loom On An Alfa MiTo.
Open the boot and take down the x2 parcel shelf supports. Pull out both ends of the rubber boot at the top,left hand side. You can pull the wires to see if there’s any obviou
Converting An After Market Window Regulator To Fit A 916 GTV/Spider
It’s always worth checking the part works before you start to modify it. Attach a power probe to the connector making sure it runs smoothly, if you haven’t got one of t
