Repairing an Alfa Romeo JTDm with broken cam or timing belt
First of all if you are unfortunate enough to have a cam belt snap on a JTDm diesel engine it is not as bad as you might expect, the engines dont USUALLY bend valves they snap the
A detailed and illustrated guide to changing the cam belt and water pump on a 156, 147 and GT JTDm
Undo 10mm bolts circled in red and pull off engine cover, it has a push fitting on the far right hand side. Under the cover you fill find quite a complicated engine, don’t le
How to replace the crankshaft sensor on an Alfa romeo TS or JTS engine
Remove the engine top cover for ease of access and then disconnect brown plug on the rear of the inlet manifold. Unclip the wire from manifold. Unclip the wire from manifold suppor
Replacing The Cam Belt, Water Pump And Variator On An Alfa 1.6/1.8 16v Engine
Lift the car up and make sure it is safe using axle stands. Then remove the road wheel, you may find it easier if you loosen the wheel nuts while the car is on the ground. Remove t
Changing the balancer shaft belt on a TS or JTS engine
Remove top engine cover Undo screws in cam belt cover Loosen right hand side front road wheel, jack the car up and make it safe. Remove under tray and right hand side inner wheel a
Replacing The EGR Valve On A 1.9 JTDM
Remove engine top cover and then disconnect this clip if fitted on your model. Then this one Disconnect the power supply to the EGR valve. Undo the bracket that retains the pipe. R
How to replace an idle control steeper motor on a CF2 engine
Undo the three screws that secure the idle stepper motor Pull the unit off the throttle spindle and then disconnect the plug Remove the unit and replace using the reverse of the pr
Replacing the cam belt on a 1750 TBi engine
In order to replace the cam belt you need to first remove the right hand front wheel, to do this carefully jack up the car to a reasonable height and make sure it is safe using axl
Changing the turbo on an Alfa 4C
Remove top engine cover, this simply pulls off. Remove dipstick Disconnect engine breather pipe and the vapour recovery system pipe. Remove turbo cooling pipe Remove turbo control
Replacing The Cam Belt On A Giulietta/MiTo/500X 1.4 TB 170hp Multiair
Remove the engine cover from its push fixings. Undo the two 10mm bolts to the expansion tank. Unscrew the expansion tanks cap to release pressure and unclip the return hose. Use on
