First make sure you have the correct bushes and you know where they go, the bushes are different at either end of the spring pan
Press out the existing worn bushes
When the bushes are out it should look like this
Clean up the welds that secure the eye to the spring pan so the spring pan sits level on the press
Dress the hole to make sure it is clean and rust free
Press in the new bush, making sure that the press only pushes on the outer ring of the bearing, DO NOT use the centre of the bearing to push the bush in because:-
1 You will damage the bush
2 It will not go in straight
Make sure both of the bearings are central in their housings.
A quick coat of paint and then you can refit the spring pan to your car.
