How To.. Strip and rebuild an Alfa Romeo Giulia Gearbox
The first thing to do is put the gear box on a nice clean bench with plenty of room so you can lay things out in order, then it is best to remove the reverse light cable from the o
Replacing The Differential Seal On A Giulia
First of all mark the two flange Undo prop shaft Using special tool undo tab washer Then undo pinion bolt using castalated socket Remove seal Using a soft hammer carefully tap in n
Fitting an Alfa Romeo Q2 Differential
First lift car off floor and make sure it is secure and then remove the front road wheels and put in a safe place. Remove engine undertray and put in a safe position, then drain ge
Changing A Left Hand Differential Seal On A MiTo 1.4
Take off the front left hand wheel. Remove the undertray. Undo the 12mm allen filler plug for the gearbox…. …and the drain plug. Drain the gearbox oil into a suitable c
Replacing The Stop & Start Sensor On A Giulietta
Make sure the vehicle is in neutral, undo the velcro that secures around the cursor, dip your hand in and release the clips that holds the gaiter surround. These are the clips that
Removing The Drive Shafts From An Alfa 159/Brera
Undo the 17mm wheel bolts and remove the wheel. Tap out the top of the hub nut that locks into the spline at the end of the CV joint. Now undo the 36mm hub nut. Undo the x2 T30 (TO
Replacing The Bushes In The Gear Selector Plate On An Alfa 147/GT/156 Twin Spark Or JTS
The gear selector plate is located down at the back of the gear box. Pinch the x2 orange tabs on the end of the gear cable connected to the ball end of the linkage pivot bolt to re
Removing The Gearbox From An Alfa 4C
Remove the rear tail light in the boot lid, unplug it then take off the boot lid. Remove the engine cover. Unclip the intercooler hose, disconnect the battery then remove it and it
Replacing The Stop And Start Sensor On A MiTo
Unbutton the top of the gear stick gaitor. Unclip the gaitor. Disconnect the connector and slide the bottom part from the bracket. Using a fastener removal tool prise off the x4 &#
The correct way to check your oil
1:- Park car on level ground and remove dip stick, It is best to do this warm but doing it cold is a lot better than not doing it at all (Note, the dipstick may be in a different p
