Remove road wheel, remember that you need to make sure the vehicle is securly supported and if you haven’t got a nut gun you will need to loosen the wheel nuts on the floor
Remove the brake caliper taking note of where the wire clip on the outside of the caliper goes (round the inside of the carrier)
Remove brake pad carrier
And remove brake disk
With a chisel undo locking tab on drive shaft nut, remembering on reassembly you need to tap it back over
Undo track rod end and ABS wire from car, we find that it is nearly impossible to get the sensor out of the hub so disconnect it from the body
Remove lower ball joint and then the two bolts that secure the hub to the shockabsorber
Press out wheel mounting flange, once this is done you will almost certainly have to remove the inner bearing race from the flange, this is best done very carefully with a grinder, taking extreme care not to damage the hub.
Remove retaining circlip
Press out the wheel bearing using a suitable drift. once this is done reassembly is the reverse of the instructions above, however when you are refitting the wheel mounting flange remember to support the back of the bearing so you dont push it out
